Polaris General 2020 Service Manual page 839

RIDE COMMAND TROUBLESHOOTING
Problem: Black Screen / Will Not Power On
STEP
Power cycle by switching ignition on and off with main power switch.
1
Did you find and repair the condition?
Check the 5amp fuse labeled INST in the main fuse box.
2
Refer to Fuse Box page
Is the fuse blown?
Reinstall INST fuse and test screen for proper operation.
3
Did you find and repair the condition?
1. Turn ignition on
2. Check for battery voltage on pin 16 (Ground), 31 (Switched Power)
4
and 32 (Battery Power) of display connector.
Is there Battery Voltage at all pins?
Refer to the wiring schematic and check circuits without voltage for
5 continuity and proper operation.
Did you find any problems in the circuit?
Replace display with known good display.
6
Did you find and repair the condition?
Repair, replace and check all affected power/ground circuits.
7 Check for battery voltage at pin 16, 31 and 32.
Is there battery voltage at pin 16, 31 and 32?
Update display with newest software available.
Refer to Update Software / Maps page
8
update/reflash software.
Is display working properly?
1. Test circuit for continuity and/or shorts in wiring.
9 2. Fix any shorts in the wiring and reinstall new fuse.
Did you find and repair the condition?
9850067 R01 - 2020-2021 GENERAL / GENERAL XP Service Manual
© Copyright Polaris Inc.
ACTION
.
for instructions on how to
FACTORY-INSTALLED OPTIONS
YES
Go to Step 8 Go to Step 2
Go to Step 9 Go to Step 3
Go to Step 8 Go to Step 4
Go to Step 8 Go to Step 5
Go to Step 1
Go to Step 7 and repeat
diagnosis
Go to Step 1
Go to Step 8 and repeat
diagnosis
Go to Step 1
Go to Step 8 and repeat
diagnosis
Confirm
display
Go to Step 6
operation and
continue use.
Go to Step 8 Go to Step 4
NO
13
13.43