Engine Removal And Installation - BOMBARDIER ski-doo Tundra Scandic 2004 Series Shop Manual

ENGINE REMOVAL AND
INSTALLATION
Disconnect or remove the following:
WARNING
Before disconnecting any electrical wire in
starter system always first disconnect the
BLACK negative battery cable (on electric start-
ing models).
– negative cable from battery
(on electric starting models)
– guard
– drive belt
– drive pulley using appropriate puller, refer to
DRIVE PULLEY
– air silencer and carburetors
– impulse line from engine crankcase
– electrical connector housings
– exhaust pipe
– oil pump inlet line and plug it
– oil pump cable
– rewind cable: tie a knot near rewind housing
and remove starting grip.
Tighten fasteners to recommended torque in ap-
propriate exploded view.
Apply high temperature RTV sealant (P/N 293 800
090) on metal-to-metal exhaust joints.
MMR2004-112_04_03A.FM
Subsection 03 (443 AND 552 ENGINE TYPES)
Section 04 ENGINE
04-03-3