Assembly - BOMBARDIER ski-doo Tundra Scandic 2004 Series Shop Manual

Table of Contents

NOTE: Make sure that the bushing is well seated

on the sliding half ass'y.

Install the circlip.

MMR2004_123_05_03A.FM

Section 05 TRANSMISSION

Subsection 03 (DRIVE PULLEY)

Spring Cover Bushing Replacement

Under normal use there is no need to replace this

If it must be replaced, it is recommended to re-

place the spring cover ass'y.

ASSEMBLY

NOTE: This drive pulley is lubrication free. Do not

lubricate any component.

1,2,3, Screw, Ring Gear and Loctite 271

Apply Loctite 271 (P/N 413 702 900) on threads and

then torque to 27 N•m (20 lbf•ft).

26,27,28, Calibration Screw, Washer

and Locking Nut

When installing calibration screw, make sure to in-

stall washer as shown.

Torque locking nut to 10 N•m (89 lbf•in).

Always use the same type of pin as originally in-

stalled when servicing. Different types have differ-

ent weights for calibration purpose. Refer to TECH-

Table of Contents