Installation - BOMBARDIER ski-doo Tundra Scandic 2004 Series Shop Manual

8, Shock Absorber
Secure the shock body end in a vise with its rod up-
ward.
1. Clamp
CAUTION: Do not clamp directly on shock body.
Examine each shock for leaks. Extend and compress
the piston several times over its entire stroke check-
ing that it moves smoothly and with uniform resis-
tance.
Pay attention to the following conditions that will
denote a defective shock:
– A skip or a hang back when reversing stroke at
mid travel.
– Seizing or binding condition except at extreme
end of either stroke.
– Oil leakage.
– A gurgling noise, after completing one full com-
pression and extension stroke.
Renew if any faults are present.
18, Support Plate
Position support plate against runner stud.
1. Runner stud
2. Support plate
MMR2004-141_08_03A.FM
Section 08 STEERING/FRONT SUSPENSION
Subsection 03 (SUSPENSION AND SKI SYSTEM)

INSTALLATION

For assembly, reverse the disassembly procedure.
However, pay attention to the following.
Apply suspension synthetic grease (P/N 293 550
033) as illustrated in exploded view above.
Tighten nuts and screws to proper torque as men-
tioned in exploded view.
Reinstall steering arm reinforcement when removed.
A22G0SA
1. Reinforcement
16,17, Seal
Install seal before reinstalling ski leg.
1
08-03-7