Installation; Oil Level - BOMBARDIER ski-doo Tundra Scandic 2004 Series Shop Manual

Finalize driven pulley shaft insertion. Make sure that
gears mesh during insertion. Install circlip no. 20.
A29D1PA
1. Circlip
Install LH side bearings nos. 12, 19 and 21, shims
no. 8, circlip no. 9 then, plugs no. 8.
A29D1OA
READY TO INSTALL BEARINGS, SHIMS, CIRCLIPS AND PLUGS
MMR2004-128_05_08A.FM

INSTALLATION

Reverse removal procedure. Check pulley alignment.

OIL LEVEL

To check, pull dipstick. Oil should reach level mark.
NOTE: After first outing, oil level will decrease as
the upper oil cavity fills with oil. Recheck oil level
and refill as required.
1
1. Full level mark
2. Lower level mark
To fill, remove filler plug from top of transmission.
Refill as required using Bombardier synthetic
chaincase oil (P/N 413 802 800 — 12 x 250 mL).
Section 05 TRANSMISSION
Subsection 08 (GEARBOX)
05-08-11