593 Engine Type; Removal From Vehicle; Installation On Vehicle - BOMBARDIER ski-doo Tundra Scandic 2004 Series Shop Manual

593 ENGINE TYPE

Skandic WT LC/SUV 600

REMOVAL FROM VEHICLE

Open hood.
Remove tuned pipe and muffler.
Drain engine coolant.
Remove or unplug the following then lift off engine
from engine compartment.
NOTE: Use of a hoist is recommended.
– guard
– air silencer
– drive belt
– rewind starter handle
– drive pulley (not necessary if engine has not to
be disassemble)
– hood
– carburetors
– impulse hose and electrical connectors
– oil injection inlet line at oil injection pump, install
hose pincher
– oil pump cable
– coolant hoses between cylinder head and radiator
– coolant by-pass hose
– coolant hose at front of coolant reservoir
– engine support screws
– engine stopper (left rear of engine).

INSTALLATION ON VEHICLE

To install engine on vehicle, reverse removal pro-
cedure. However, pay attention, to all appropriate
component/system reinstallation procedures de-
scribed throughout this Shop Manual and to the
following:
– After throttle cable installation, check carbure-
tor maximum throttle opening and oil injection
pump adjustment.
– Check pulley alignment and drive belt tension.
– Seal exhaust ball joints with Ultra Copper (P/N
413 710 300).
MMR2004-113_04_04A.FM
Section 04 ENGINE
Subsection 04 (593 ENGINE TYPE)
0
04-04-1