SUSPENSION AND TRACK
The following chart is provided to help diagnose the probable source of troubles. It should be used as a
guideline. Some causes or corrections may not apply to a specific model.
SYMPTOM
SUSPENSION IS TOO LOW.
CONDITION
NORMAL USE.
Test/Inspection
SYMPTOM
REAR SUSPENSION BOTTOMS OUT.
CONDITION
NORMAL USE.
Test/Inspection
MMR2004-110_03_06A.FM
1. Check condition of springs.
a. Springs are broken.
Replace springs.
2. Check springs preload.
a. Too low spring preload.
Increase preload to the recommended position.
3. Check springs.
a. Installed springs are too soft.
Install optional stiffer springs, refer to Service Bulletin SPRING REFERENCE
ACCORDING TO LOAD.
1. Check condition of springs.
a. Springs are broken.
Replace springs.
2. Check springs preload.
a. Too low spring preload.
Increase preload to the recommended position.
3. Check springs.
a. Springs installed are too soft.
Install optional stiffer springs, refer to Service Bulletin SPRING REFERENCE
ACCORDING TO LOAD.
4. Check the rear shock motion ratio position.
a. It is adjusted in soft position.
Adjust rear shock motion ratio to firm position.
Section 03 TROUBLESHOOTING
Subsection 06 (SUSPENSION AND TRACK)
0
03-06-1