Table of Contents
Advertisement
ON-VEHICLE COMPONENT
VERIFICATION
8, Shock
Lift front of vehicle and support off the ground.
Remove ski bolt and nut.
Remove steel bushing from ski using a pusher. See
pusher dimensions below.
A. 220 mm (8.66 in)
B. 180 mm (7.09 in)
C. 70 mm (2.75 in)
D. 25 mm (1.0 in)
E. 15 mm (0.59 in)
F. 9 mm (0.35 in)
A22G0PA
Unfasten rod nut then pull out shock from bottom.
Check shock as described below in INSPECTION.
At installation, make sure bushings are in place.
MMR2004-141_08_03A.FM
Section 08 STEERING/FRONT SUSPENSION
Subsection 03 (SUSPENSION AND SKI SYSTEM)
1. Bushings
7, Spring
Unscrew shock rod nut then remove washer. Un-
screw 3 Allen screws retaining cover no. 3, then re-
move stopper no. 5, washers no. 6, washer no. 19.
A05G0CA
1. Allen screws
NOTE: These washers and stopper can be wedged
in cover.
1
08-03-5
Advertisement
Chapters
Table of Contents
Troubleshooting
