Assembly - BOMBARDIER ski-doo Tundra Scandic 2004 Series Shop Manual

TYPICAL — ALL SKANDIC MODELS
NOTE: Two different types of sprocket press fit
can be found. Ensure to replace ring reinforced
sprockets with the same type.

ASSEMBLY

8,9,13, Drive Axle and Sprocket
To assemble press fit sprockets, use a press and
a suitable pipe as illustrated. Sprockets must be
assembled according to the following dimensions.
A00F07A
TYPICAL — TUNDRA
1. Pipe
MMR2004-138_07_05A.FM
TYPICAL — ALL SKANDIC MODELS
1. Pipe
Tundra
TYPICAL
1
1. Chaincase side
2. Center line of sprocket
3. Drive axle end
A. 83.0 mm (3-17/64 in)
B. 237 mm (9-21/64 in)
Section 07 REAR SUSPENSION
Subsection 05 (DRIVE AXLE)
07-05-5