Ducati Trigger Coil Cdi System Testing; Ignition System Testing Sequence - BOMBARDIER ski-doo Tundra Scandic 2004 Series Shop Manual

Enter new calibration number and press ENTER,
following screen appears:
Simultaneously with the following operation a
transfer will occur; Trs. At this point, be ready
to rev the engine so it won't fall below the 2000
RPM mark when not using 9-volt adaptor.
Plug-in the desired calibration cartridge (special
red key) onto the programmer post, the following
screens will appear temporarily:
T R A N S F E R
V E R I F Y
A00A41A
T R A N S F E R
P G M R
A00A42A
MMR2004-134_06_06A.FM
+
M P E M
Section 06 ELECTRICAL
Subsection 06 (TESTING PROCEDURE)
O P E R A T I O N
S U C C E S S F U L L
P R E S S A N Y K E Y . . .
A00A3EA
Press any key, display will show followed by next
screen:
Press MENU twice, following screen will show:
After procedure is completed, ensure engine idle
speed with engine hot is 1700 - 2100 RPM.
Stop the engine.
DUCATI TRIGGER COIL CDI
SYSTEM TESTING
Skandic WT/SWT/SUV 550
IGNITION SYSTEM TESTING
SEQUENCE
In case of ignition problems, check the following
in the prescribed order until the problem can be
solved.
1. Sparking/spark plug condition.
2. Electrical connectors.
06-06-7