DRIVE BELT
APPLICATION CHART
MODEL
Tundra
Skandic LT/LT E/WT/SWT/WT LC/SUV 550
Skandic WT LC/SUV 600
CHECKING NEUTRAL FUNCTION
WARNING
Always check neutral function when servicing.
Apply parking brake. Vehicle must be on the ground
and on a plane level surface. No one should be in
front of vehicle.
Attach vehicle tether cord to your clothing. Stand
aside of vehicle then, start engine.
WARNING
Do not sit on vehicle.
Release parking brake. Vehicle must not creep when
engine is idling. Otherwise, make sure that:
– idle speed is as specified
– proper belt is installed
– pulley center-to-center is as specified
– belt deflection is as specified.
CLEANING
Before drive belt installation, clean drive and driven
pulley sheaves with Pulley flange cleaner (P/N 413
711 809).
INSPECTION
Inspect belt for cracks, fraying or abnormal wear
(uneven wear, wear on one side, missing cogs,
cracked fabric). If abnormal wear is noted, proba-
ble cause could be pulley misalignment, excessive
RPM with frozen track, fast starts without warm-
up period, burred or rusty sheave, oil on belt or
distorted spare belt.
MMR2004-122_05_02A.FM
Section 05 TRANSMISSION
Subsection 02 (DRIVE BELT)
PART NUMBER
414 827 600
414 633 800
414 300 155
Check the drive belt width. Replace the drive belt
if width is less than the minimum width recom-
mended (see table above).
ROTATION DIRECTION
The maximum drive belt life span is obtained when
the drive belt is installed as shown. This will en-
sure that correct direction of rotation is respected.
CORRECT
0
MINIMUM WIDTH
(wear limit)
30.0 mm (1.181 in)
32.0 mm (1.260 in)
34.7 mm (1.366 in)
05-02-1