Engine - BOMBARDIER Elan Shop Manual

SECTION 04
SUB-SECTION 02 (ENGINES)
®
To remove bearing from crankshaft use a protective
cap and special puller as illustrated. (See Tool Section).
Bearing puller
O
NOTE: Prior to magneto side bearing installation,
determine crankshaft end-play and install required
shirnts) on crankshaft extension.
At assembly, place bearings into an oil container and
heat the oil to 100°C WO°F) for 5 to 10 min. This will
expand the bearings and permit them to slide easily on
the shaft. Install bearings with groove outward.
G)At assembly apply a light coat of lithium grease on
seal lips then position oil seal with outer surface flush
with crankcase.
@To remove or install magneto retaining nut, lock
crankshaft in position with special hold-on support as il-
lustrated. (See Tool Section).
Flywheel
·II1!n""o.....
hold-on
support
At assembly torque retaining nut to:
Engine
type
(
I
248
294
61 N-m (45 ft-lbs)
85 N-m (63 ft-Ibs)
@@Torque to 22 N-m (16 ft-lbs).
@Torque to 12 N.m (9 tt-lbs).
(248,294 ENGINE TYPES), PAGE 6
(,