Removal; Disassembly - BOMBARDIER ski-doo Tundra Scandic 2004 Series Shop Manual

Section 07 REAR SUSPENSION
Subsection 05 (DRIVE AXLE)

REMOVAL

Tundra R and Skandic LT/LT E
Drain oil from chaincase. Release drive chain ten-
sion. Remove chaincase cover.
Raise and block rear of vehicle off the ground.
Remove suspension. Refer to SUSPENSION.
2,8, End Bearing Housing and Seal
Remove cable protector no. 7, and plastic bearing
cover. Remove circlip no. 14 from drive axle.
Remove chain and sprocket then circlip and bear-
ing no. 12 from drive axle.
Pry oil seals from chaincase and end bearing hous-
ing.
6,9,13, Drive Axle and Sprocket
Release drive axle sprocket from track and at the
same time, pulling the drive axle towards the end
bearing housing side.
Remove drive axle from vehicle.
Skandic WT/SWT/WT LC/SUV 550/SUV 600
Drain gearbox.
Remove angle drive no. 1 and square pin no. 4.
Raise and block rear of vehicle off the ground.
Remove suspension. Refer to SKANDIC WT SUS-
PENSION.
Remove muffler. Unfasten screw from drive axle
end. Loosen Allen screw on bearing race.
1. Allen screw
2. Screw
07-05-4
Remove 3 screws retaining ball bearing housing
then, remove inner plate no. 3.
Remove drive axle.

DISASSEMBLY

4, Speedometer Drive Insert
Remove speedometer drive insert.
5,12, Bearing
Tundra Only
To remove bearings, use puller assembly, ring and
half rings as illustrated.
9,13, Sprocket and Half-Sprocket
To remove press fit sprockets, use a press and a
suitable support as illustrated.
1
A00F06A
TYPICAL — TUNDRA
1. Support sprocket near hub
MMR2004-138_07_05A.FM