Section 07 REAR SUSPENSION
Subsection 03 (SKANDIC WT SUSPENSION)
INSTALLATION
Threaded holes must be cleaned before a self-locking
screw is installed. Use a metal brush or a screwtap
to clean the hole properly then use a solvent (Methyl-
Chloride), let act during 30 minutes and wipe off.
The solvent utilization is to ensure the adhesive
works properly.
Use a tie-down between front arm and spring axle
to ease installation of front arm screws.
RIDE ADJUSTMENT
Refer to Operator's Guide.
07-03-4
MMR2004-136_07_03A.FM