Component Removal; Suspension Ass'y Removal; Disassembly And Assembly - BOMBARDIER ski-doo Tundra Scandic 2004 Series Shop Manual

Section 07 REAR SUSPENSION
Subsection 02 (TORQUE REACTION SUSPENSION)

COMPONENT REMOVAL

Lift rear of vehicle and support it off the ground.
5, Rear Arm
Release track tension.
Release spring tension. Unfasten shock from rear
arm. Remove 3 screws retaining rear arm.

SUSPENSION ASS'Y REMOVAL

Release track tension.
NOTE: To prevent cross shaft from turning when
unscrewing screws assembled with threadlocker,
proceed as follows:
– Loosen one screw then retighten.
– Remove the other screw.
– Remove the first one.
1,2,3,4, Cross Shaft, Idler Wheel, Spacer
and Screw
Remove idler wheel ass'y.
Suspension Ass'y
Lift rear of vehicle and support it off the ground.
Unscrew 4 screws retaining front arm and rear arm
to frame.
Remove suspension.

DISASSEMBLY AND ASSEMBLY

6, Stopper Strap
When assembling make sure it is attached through
rd
the 3 hole from the end. Torque nut to 11 N•m
(97 lbf•in).
07-02-2
1. 1 st hole
2. 3 rd hole
A. 11 N•m (97 lbf•in)
9,10,12, Nut, Slotted Screw and Slider
Shoe
To replace a worn shoe, remove the front screw
and stop nut, then slide the shoe rearward out of
the runner.
1. Front screw and nut
CAUTION: Slider shoes must always be replaced
in pairs.
MMR2004-135_07_02A.FM