Disassembly; Cleaning; Inspection - BOMBARDIER ski-doo Tundra Scandic 2004 Series Shop Manual

DISASSEMBLY

Unscrew nut. Remove tab washer.
Check for alignment marks for proper indexing at
reassembly.
A03D2IA
1. Alignment marks
Identify blocks no. 1 and their respective positive
positions for reassembly.
A05D0LA
1. Identify
MMR2004_123_05_03A.FM
1
1
1
Section 05 TRANSMISSION
Subsection 03 (DRIVE PULLEY)
2, Cap, Washer and Disk
These are calibration parts. Refer to TECHNICAL
DATA.
Install spring cover tool (P/N 529 027 300) with
puller (P/N 529 022 400) on spring cover.
1
A03D2HA
1. Puller tool
2. Spring cover tool
Screw puller (hand tight) to hold spring cover and
remove screws holding spring cover.
Slowly unscrew puller to release spring pressure.
Remove spring cover no. 5, spring and spring seat
no. 11.

CLEANING

Clean pulley faces and shaft with fine steel wool
and clean dry cloth. Clean sliding half bushing with
clean dry cloth.

INSPECTION

Check sliding half for excessive lateral play and
fixed half shaft for scratches. Replace as required.
2
05-03-3