On-Vehicle Component Removal; Disassembly - BOMBARDIER ski-doo Tundra Scandic 2004 Series Shop Manual

Section 08 STEERING/FRONT SUSPENSION
Subsection 03 (SUSPENSION AND SKI SYSTEM)
ON-VEHICLE COMPONENT
REMOVAL
8, Shock
Lift front of vehicle and support off the ground.
Remove ski.
Unscrew shock rod piston pin nut then remove wash-
er. Unscrew 3 Allen screws retaining cover no. 3,
then remove stopper no. 5, washers no. 6, wash-
er no. 7.
A05G0CA
1. Allen screws
NOTE: These washers and stopper can be wedged
in cover.
A05G0DA
1. Washers and stopper wedged in cover
2. Spring
Pull out spring then check shock as described be-
low in INSPECTION.
08-03-2

DISASSEMBLY

Lift front of vehicle and support off the ground.
1,2,3,5,6,7,9,11, Bolt, Lock Washer, Cover,
Stopper, Bushing, Cushion and Nut
Remove ski bolt, nut, bushings and ski.
Unscrew shock rod nut then remove washer. Shock
will fall off the ski leg.
Unscrew 3 Allen screws retaining cover, then re-
move stopper and washers.
1
A05G0CA
1. Allen screws
NOTE: These washers nos. 6 and 7 and stopper
no. 5 can be wedged in cover.
4,13,14,16,17, O-Ring, Ski Leg, Upper
1
Cushion, Lower Cushion and Seal
Pull up ski leg. Steering arm will not interfere.
2
A05G0EA
1. Pull up ski leg
2. Steering arm in place
1
1
2
MMR2004-141_08_03A.FM