Disassembly; Inspection - BOMBARDIER ski-doo Tundra Scandic 2004 Series Shop Manual

DISASSEMBLY

5, Shock
Lift front of vehicle and support it off the ground.
Reduce spring preload by turning adjusting ring ac-
cordingly.
Remove lower bolt then upper bolt of shock.
For shock spring disassembly use shock spring re-
mover (P/N 529 035 504) in a vise. Mount shock in
it and turn shock so that spring coils matched spring
compressor.
Close and lock the bar. Adjust the handle at hori-
zontal position by changing the position of the cle-
vis pin.
3
A01B4LA
1. Clevis pin
2. Bar
3. Handle horizontal
Push down on the handle until it locks. Remove
spring stopper then release handle.
1, Swing Arm
Lift front of vehicle and support it off the ground.
Remove cap no. 4, circlip no. 3.
MMR2004-141_08_03A.FM
Section 08 STEERING/FRONT SUSPENSION
Subsection 03 (SUSPENSION AND SKI SYSTEM)
1
Scribe mark the steering arm and ski leg before
disassembly.
Then loosen steering arm bolt and pull up steering
arm. Ski leg may fall off from swing arm.
Unbolt lower end of shock from swing arm.
Unbolt upper and lower arms.
2
Unbolt rear of swing arm from frame.
Pull swing arm off the vehicle.

INSPECTION

Check all rubber cushions for crack and wear. Re-
place as required.
Check straightness of ski leg no. 12 and make sure
that splines are properly interlocking with steering
arm. Replace as required.
Check for straightness of swing arm. Replace as re-
quired.
Check for clogged grease fittings. Clean or replace
as required.
Check skis and runners no. 10 for wear, replace as
necessary.
Check condition of ski stopper no. 9. Replace it when
deteriorated.
To check condition of shock, refer to SHOCK AB-
SORBER in INSPECTION CHAPTER.
08-03-9