Belt Guard; Drive Belt Removal And Installation - BOMBARDIER Alpine 1987 Operator's Manual

Belt guard
I
pulley guard
removal
•
WARNING: Engine should be run-
ning only when belt guard and/or
pulley guard are secured in place.
1. Remove hood. Pull out retaining clip
(A) and tilt belt guard towards front
of vehicle. If necessary to remove, lift
out.
A017003020
A
2. Pull out retaining clip
(B).
3. Push button (C) towards engine.
4. Lift and pull guard to disengage com-
pletely from rear bracket
(D).
A017003021
Pulley
guard
5. Move pulley guard towards front of
vehicle to disengage from front at-
taching device (E).
Drive belt removal
and installation
•
WARNING: Never start or run
the engine without the drive belt
installed. Running an unloaded engine
is dangerous.
1. Remove hood, belt guard and pulley
guard.
2. Remove the two bolts (A) holding
bearing support to the frame.
A017003020
3. Pivot the bearing support assembly
half a turn.
4. Open the driven pulley by twisting
and pushing the sliding half.
A002003023
5. Hold in open position.
6. Slip the belt over the top edge of the
fixed half.
______________________ 23