Table of Contents
Advertisement
LUBRICATION
Frequency
Routine maintenance is necessary for
all
mechanized
and
the
snowmobile is no exception. A
vehicle inspection contributes to
life span of the snowmobile as well as
retains safe and dependable "' ..... "'. . .
.."+.,.-.,,,....,
It is
that the
system, suspension and drive axle
lubricated monthly or every
40
hours of
operation. If the vehicle is operated in
wet snow or in severe conditions these
items should be lubricated more fre-
quently .
.... WARNING: Only perform such
..... procedures as detailed in this
manual. It is recommended that dealer
assistance be periodically obtained on
other components/systems not cov-
ered in this manual. Unless otherwise
specified, engine should be turned OFF
for all lubrication and maintenance pro-
cedures.
Belt Guard Removal
.... WARNING:
Engine should be
..... running only when belt guard is
secured in place.
1.
Tilt the hood, remove both belt
guard retaining clips
(A).
2. Pullout
r'c>'t">,n,n,....
pin (B).
.... WARNING: At the removal or in-
..... stallation of the belt guard front
retaining pin be careful not to burn
yourself on the exhaust system.
3.
Lift
and remove the
belt guard
assembly.
Drive Belt Removal
...... WARNING: Never start or run
..... engine without the drive belt in-
stalled. Running an unloaded engine is
dangerous.
1. Tilt the hood and remove the belt
guard.
2.
Open the driven pulley by twisting
and pushing the sliding half. Hold in
fully open position.
3.
Slip the belt over the top edge of the
sliding half.
4.
the belt out from the drive pul-
ley and remove completely from the
vehicle. To install the drive belt,
reverse the
orocedure
17
Advertisement
Table of Contents
