Handlebar Position Adjustment - BOMBARDIER ski-doo Tundra Scandic 2004 Series Shop Manual

21, Hardened Washer on Ball Joint Stud
Tundra and Skandic SUV 550/SUV 600
Install a hardened washer on each side of the arm.
1
A25G0MA
TYPICAL
1. Hardened washers
17, Steering Arm
Tundra
Steering arm notch must face outside of vehicle.
1
A05G0CB
1. Notch facing outside
Skandic LT/LT E/WT/SWT/WT LC
Install steering arm at mid-travel position when
handlebar and skis are facing straight ahead.
MMR2004-140_08_02A.FM
Section 08 STEERING/FRONT SUSPENSION
Subsection 02 (STEERING SYSTEM)
TYPICAL
Skandic SUV 550/SUV 600
Steering arm must be installed parallel to ski.
9,13,15, Ball Joint Nut and Jam Nut
Tighten ball joint nuts and jam nuts to specified
torque (see exploded view).
HANDLEBAR POSITION
ADJUSTMENT
All Models
Remove steering cover and paddings. Loosen 4
nuts on steering clamps no. 2.
1. Nuts to be removed
Adjust the steering handlebar to the desired posi-
tion.
Lock the handlebar in place by tightening the 4
nuts as specified in the illustrations.
08-02-7