Disassembly - BOMBARDIER ski-doo Tundra Scandic 2004 Series Shop Manual

Install holder (P/N 529 006 400) in a way to limit
pulley clockwise rotation.
Insert drive pulley puller (P/N 529 025 000) then
turn puller clockwise to free drive pulley from
crankshaft taper.
Remove driven pulley to make room for drive pul-
ley removal.
Remove drive pulley.

DISASSEMBLY

Skandic LT E Only
Remove retaining screws no. 17 and washers
no. 18 from ring gear no. 19.
CAUTION: Retaining screws must be heated be-
fore disassembly. Heating temperature must
not exceed 150°C (300°F).
Skandic LT and Skandic LT E
Mount tapered tool (P/N 529 035 826) in a vise.
Install drive pulley over retainer then, fasten retain-
ing screw no. 1 and torque to 68 N•m (50 lbf•ft).
Now drive pulley is locked on retainer.
Scribe pen marks on fixed half no. 16, sliding half
no. 10, spider no. 5 and cover no. 3 for proper in-
dexing at reassembly.
MMR2004_123_05_03A.FM
Section 05 TRANSMISSION
Subsection 03 (DRIVE PULLEY)
1. Scribe marks
Remove cover screws no. 2.
Hold cover no. 3 by hand then, unscrew retaining
screw no. 1.
Remove cover no. 3.
05-03-7