Activation Of New Battery - BOMBARDIER ski-doo Tundra Scandic 2004 Series Shop Manual

Section 06 ELECTRICAL
Subsection 04 (BATTERY)
Clean battery casing and caps using a solution of
baking soda and water. Do not allow cleaning so-
lution to enter battery, otherwise it will destroy the
electrolyte. Rinse battery with clear water and dry
well using a clean cloth.
Store battery in a cool dry place. Such conditions
reduce self-discharging and keep fluid evaporation
to a minimum.
During the storage period, recheck electrolyte lev-
el and specific gravity readings at least every 40
days. As necessary, keep the battery at its upper
level line and near full charge as possible (trickle
charge).
Skandic WT/SWT/SUV 550/SUV 600
Disconnect and remove battery from the vehicle.
The battery must always be stored in fully charged
condition.
Clean battery terminals and cable connections using
a wire brush. Apply a light coat of dielectric grease
(P/N 293 550 004) or petroleum jelly on terminals.
Clean battery casing using a solution of baking
soda and water. Rinse battery with clear water and
dry well using a clean cloth.
Charge the battery every month if stored at a tem-
perature below 15°C (60°F).
Charge the battery every two weeks if stored at a
temperature above 15°C (60°F).

ACTIVATION OF NEW BATTERY

Skandic WT/SWT/SUV 550/SUV 600
Refer to the instructions provided with the battery.
Skandic LT E
WARNING
Never charge or boost battery while installed
on vehicle.
CAUTION: Prior to charging the battery, always
remove it from the vehicle to prevent electro-
lyte spillage.
A new battery is factory fresh dry charged. For stor-
age purposes, it is fitted with a temporary sealing
tube.
Do not remove the sealing tube or loosen battery
caps unless activation is desired.
06-04-4
In case of accidental premature removal of caps or
sealing tube, battery should be given a full charge.
Perform the following operations anytime a new
battery is to be installed.
1. Remove the sealing tube from the vent elbow.
Install vent tube, included in the battery kit, to
battery elbow.
WARNING
Failure to remove the sealing tube could re-
sult in an explosion.
A17E0FA
1. Battery electrolyte
2. Remove caps and fill battery to UPPER LEVEL
line with electrolyte (specific gravity: 1.265 at
20°C (68°F)).
3. Allow the battery to stand for 30 minutes MIN-
IMUM (1 hour MAXIMUM) so that electrolyte
soaks through battery cells.
1. 30 minutes
1
MMR2004-132_06_04A.FM