Lubrication - BOMBARDIER ski-doo Tundra Scandic 2004 Series Shop Manual

1. Pivot arm pointing straight forward
2. Idler arm pointing straight forward too
TOE-OUT ADJUSTMENT
With the handlebar in straight ahead position, turn
left and right tie rods no. 20 to obtain specified
toe-out.
Procedure:
– Loosen jam nuts no. 13 and no. 15 of both tie
rods no. 20.
WARNING
Never lengthen tie rod making threaded por-
tion of ball joint exceed 20 mm (25/32 in).
– Close front of skis manually to take all free-play
from steering mechanism.
NOTE: A rubber cord must be hooked in front of
skis to keep them closed.
Skis should have a toe-out of 5 mm (3/16 in) when
they are in a straight-ahead position and the vehi-
cle is resting on the ground.
Measurements are taken 250 mm (10 in) at front
and rear of ski pivot bolt.
NOTE: To make sure skis are in a straight-ahead
position, place a straight edge against pre-adjusted
track and measure the distance between front and
rear of skis and straight edge. Distances should be
equal. After the ski toe-out adjustment, distance
at front of ski must be 2.5 mm (3/32 in) more than
at rear on both sides for a total toe-out of 5 mm
(3/16 in).
MMR2004-140_08_02A.FM
Section 08 STEERING/FRONT SUSPENSION
Subsection 02 (STEERING SYSTEM)
Skandic LT/LT E/WT/SWT/WT LC
Toe-out adjustment is performed by adjusting
length of left and right tie rods no. 20. Handlebar
centering is done at same time by turning tie rods
accordingly.
Procedure:
– Loosen jam nuts no. 13 and no. 15 of both tie
rods no. 20.
Never lengthen tie rod making threaded por-
tion of ball joint exceed 20 mm (25/32 in).
– Close front of skis manually to take all free-play
from steering mechanism.
NOTE: A rubber cord must be hooked in front of
skis to keep them closed.
Skis should have a toe-out of 5 mm (3/16 in) when
they are in a straight-ahead position and the vehi-
cle is resting on the ground.
Measurements are taken 250 mm (10 in) at front
and rear of ski pivot bolt.
NOTE: To make sure skis are in a straight-ahead
position, place a straight edge against pre-adjusted
track and measure the distance between front and
rear of skis and straight edge. Distances should be
equal. After the ski toe-out adjustment, distance
at front of ski must be 2.5 mm (3/32 in) more than
at rear on both sides for a total toe-out of 5 mm
(3/16 in).

LUBRICATION

Do not lubricate throttle and/or brake cable
nor their housing.
The following symbols will be used to show what
type of lubricant should be used at the suitable
locations.
1. Synthetic grease (P/N 413 711 500)
2. Penetrating lubricant (P/N 293 600 016)
WARNING
WARNING
08-02-11