Countershaft Lubrication; Pulley Protection; Vehicle Protection; Rags In Air Intake And Exhaust System - BOMBARDIER ski-doo Tundra Scandic 2004 Series Shop Manual

Section 02 MAINTENANCE
Subsection 03 (STORAGE)
Proceed as follows:
Start the engine and allow it to run at idle speed
until the engine reaches its operating temperature.
WARNING
Ensure the track is free of all particles which
could be thrown out while it is rotating. Keep
hands, tools, feet and clothing clear of track.
Ensure no one is standing in close proximity
to the vehicle.
Stop the engine.
Models with a Primer
To prevent fuel from draining, primer button
should be pushed all the way in.
Disconnect the outlet primer hose from the primer
valve (straight coupling).
1. Straight coupling
2. To intake manifold
Insert storage oil nozzle into primer outlet hose.
Models with a Choke
Remove air silencers to spray storage oil into each
carburetor bore.
All Models
Restart engine and run at idle speed.
Inject storage oil until the engine stalls or until a
sufficient quantity of oil has entered the engine
(approximately half a can).
With the engine stopped, remove the spark plug
and spray storage oil into each cylinder.
02-03-2
Crank slowly 2 or 3 revolutions to lubricate cylin-
ders.
Reinstall the spark plugs and the outlet primer
hose or air silencers.
WARNING
This procedure must only be performed in a
well-ventilated area. Do not run engine dur-
ing storage period.

COUNTERSHAFT LUBRICATION

Driven pulley and brake disc must be floating on
the countershaft for efficient operation. Lubricate
with anti-seize lubricant (P/N 293 800 070).
CAUTION: Do not lubricate excessively as lu-
bricant could contact and soil brake pads and/
or drive belt.

PULLEY PROTECTION

After inspection and interior cleaning of pulleys,
spray BOMBARDIER LUBE (P/N 293 600 016) on
sheaves. Do not reinstall drive belt.

VEHICLE PROTECTION

Protect the vehicle with a cover to prevent dust
accumulation during storage.
CAUTION: The snowmobile has to be stored in
a cool and dry place and covered with an opaque
but ventilated tarpaulin. This will prevent sun
rays and grime from affecting plastic compo-
nents and vehicle finish.
Lift rear of vehicle until track is clear of the ground.
Install on a snowmobile mechanical stand.
NOTE: Do not release track tension.
RAGS IN AIR INTAKE AND
EXHAUST SYSTEM
Block air intake hole and exhaust system hole us-
ing clean rags.
MMR2004-104_02_03A.FM