Section 05 TRANSMISSION
Subsection 03 (DRIVE PULLEY)
ASSEMBLY
Install spring seat no. 11 then the spring and its
cover no. 5.
Make sure to install blocks in their original position
and with their curved end toward governor cup.
See following illustration.
1. Curved end
Tighten nut no. 8 to 128 N•m (94 lbf•ft).
INSTALLATION
Torque screw to 80 to 100 N•m (59 to 74 lbf•ft).
Install drive belt and belt guard.
Raise and block the rear of the vehicle and support
it with a mechanical stand.
WARNING
Make sure the track is free of particles that
could be thrown out while track is rotating.
Keep hands, tools, feet and clothing clear of
track. Ensure nobody is standing near the
vehicle.
Accelerate the vehicle at low speed (maximum
30 km/h (20 MPH)) and apply the brake, repeat
5 times.
Re-torque screw to 90 to 100 N•m (66 to 74 lbf•ft).
WARNING
After 10 hours of operation the transmission
system of the vehicle must be inspected to
ensure the retaining screw is properly torqued.
05-03-4
MMR2004_123_05_03A.FM