Stratasys J850 User Manual page 42

Stratasys J850/J835 User Guide
Important:
Clicking Home sends the tray back to the Home position and the current
tray position is not saved. In the next attempts, make sure that you
increment by 10 steps each time. For example, in your second attempt,
raise or lower the tray by 20 steps and try again.
17. Repeat the process from step 14 over the entire surface of the build tray
Caution:
Moving the print block manually induces an electrical current that can
damage components. Move the print block slowly to minimize the current
and reduce the risk of damage.
18. When there is slight friction with the roller over the entire build tray surface,
19. Click Save to save the new build tray height start position.
20. Move the print block to the left rear corner of the printer.
Caution:
Moving the print block manually induces an electrical current that can
damage components. Move the print block slowly to minimize the current
and reduce the risk of damage.
21. Close the printer cover and click Lock Door.
DOC-18001 Rev. H
h. Using the transparency sheets, check if there is friction between the tray
and the roller. If not, repeat the above steps until there is slight friction.
and make sure that there is slight firction in all areas.
type the value from the Position field into the Goto field.
Figure 4-16 Entering the Position value in the GoTo field
4 Operating and Maintaining the Printer
4-14