Stratasys J850 User Manual page 138

Stratasys J850/J835 User Guide
15. Inspect the new UV reflector, and make sure that a black strip is attached to
16. Discard the old UV reflector and lamp.
Dispose of the used UV lamp in accordance with environmental and safety
requirements.
Warning: Broken UV lamp hazard
UV lamps contain mercury. Deal with broken lamps with caution.
l
l
l
l
17. Insert the UV reflector unit into the housing, next to the print block.
DOC-18001 Rev. H
the inside of it. If not, install one—on the side of the reflector opposite (not
next to) the print block.
Note: Extra black strips are included in the printer Start-Up Kit. If
necessary, you can remove the black strip from the old reflector and install it
in the new reflector (as long as the black paint has not faded).
Ventilate the room thoroughly.
Use protective gloves when collecting mercury and lamp components.
Remove spilled mercury with a method that prevents the generation of
mercury vapor, such as a syringe, packing tape or paper.
Place the broken lamp, mercury and contaminated materials in an air-tight,
non-metallic container.
Figure 4-168 Print block and UV lamp assembly, showing correct
placement of black strip
4 Operating and Maintaining the Printer
4-110