Stratasys J850 User Manual page 41

Stratasys J850/J835 User Guide
14. Slide the transparency sheets back and forth under the print block.
Caution:
Too much friction between the roller and the fabric may damage the fabric.
Make sure that the roller only slightly contacts the transparency sheets.
15. If there is some slight friction, continue with step17 If not, continue with step
16. If there is no friction or too much friction, continue as follows:
Caution:
Moving the print block manually induces an electrical current that can
damage components. Move the print block slowly to minimize the current
and reduce the risk of damage.
DOC-18001 Rev. H
The transparency sheets should slide in and out from under the print block
and you should feel some friction between the roller and the transparency
sheets.
16, below.
a. Move the print block to the left rear corner of the printer.
b. Remove the transparency sheets from the printer.
c. Close the printer cover and click Lock Door.
d. Select the Enable check box.
e. Click Home and click Goto.
f. Raise or lower the build tray by 10 steps.
To do this, in the Move field, type 10 to lower the tray, or -10 to raise
the tray, and click Move.
Note: To raise the tray, enter a negative value. To lower the tray, enter
a positive value.
Figure 4-15 Raising the tray by 10 steps (J850 3DFashion)
g. Click Unlock Door and open the printer cover.
4 Operating and Maintaining the Printer
4-13