Stratasys J850 User Manual page 47

Stratasys J850/J835 User Guide
6. In GrabCAD Print, make sure that the correct slice number is entered in the
7. If, for any reason, the correct number does not appear in the dialog box,
You cannot continue printing if:
• The number of the last slice printed does not appear in the printer interface,
• There was a relatively long interruption in printing, even if the "last slice" and
DOC-18001 Rev. H
dialog box.
Figure 4-20 Slice confirmation in GrabCAD Print
Figure 4-21 Printer interface after interrupted printing
enter the number and click OK.
even if the server computer displays the confirmation dialog box.
indicators are correct. This is because the part already printed might slightly
deform or shrink before printing continues, causing a visible difference
between it and the part printed later. The effects of a printing stoppage
4 Operating and Maintaining the Printer
4-19