Stratasys J850 User Manual page 136

Stratasys J850/J835 User Guide
10. Before continuing, inspect the spring-loaded pins. If there are burn marks
11. Using the polyurethane tube provided in the kit, push the new UV lamp bulb
DOC-18001 Rev. H
around the pins or if the pins are loose—their springs are not functioning
properly—and do not support the bulb, continue with step
UV reflector.
Otherwise, continue with step 8 to replace the UV bulb.
Figure 4-163 Spring-loaded pin
into the UV reflector. Make sure that the tip on the bulb is facing the slot.
Figure 4-164 Pushing the new UV bulb into the UV reflector
4 Operating and Maintaining the Printer
, to replace the
15
4-108