Stratasys J850/J835 User Guide
3. When the following screen appears, place the transparency on the build
4. Make sure that the transparency sheet is lying flat, and tape it to the tray.
5. Close the printer cover.
6. In the wizard screen, select the check box to confirm that the transparency
7. If the printer is currently loaded with seven model materials (High Mix /
DOC-18001 Rev. H
tray—next to the left and rear edges of the tray (see below).
Figure 4-74 Transparency confirmation
Figure 4-75 Positioning the transparency on the build tray
sheet is secured to the build tray, and click Next.
High Quality mode), select the mode for aligning the print heads.
Figure 4-76 Mode selection
4 Operating and Maintaining the Printer
4-58