Stratasys J850 User Manual page 125

Stratasys J850/J835 User Guide
To replace pump tubes, you replace the entire pump "cassette" in the printer.
Replacement cassettes are supplied in the printer Start-up Kit. Additional
cassettes can be ordered from your Stratasys service provider.
To replace the waste pump tubes:
1. Make sure that the printer is in Idle mode (see the figure on page 4-4).
2. Using an 8-mm hex (Allen) key, open the two latches that secure the left
3. Open the panel and disconnect the ground (earth) wire.
4. Remove the panel.
DOC-18001 Rev. H
Note: The printer enters Idle mode about 16 minutes after printing stops.
To force the printer into Idle mode, close the printer application: From the
File menu, click Exit.
printer panel (as you face the printer).
Figure 4-144 Opening a panel latch
Figure 4-145 Ground wire connected to panel
4 Operating and Maintaining the Printer
4-97