Stratasys J850 User Manual page 52

Stratasys J850/J835 User Guide
7. For Support material, select the number of cartridges to replace.
8. If the color or mechanical properties of the first 3D prints are unimportant,
9. To flush out material currently in the system, choose the flushing cycle that
The default flushing cycle is the one used for the last material replacement.
There are additional settings that you can select for special purposes (see
"Advanced Settings"). If necessary, click Advanced Settings before
clicking Next.
DOC-18001 Rev. H
❒ In High Mix / High Quality and High Speed modes, you can print using
one or two Support cartridges.
❒ In Super High Speed mode, at least two Support cartridges are
required; you can print with up to four Support cartridges.
and if you did not change the printing mode (High Quality/Speed) you can
replace the model materials without flushing out the current materials. To
do so, continue with "Changing Model Materials Without Flushing" on
page 4-26.
fits your needs:
❒ Economy. This cycle can be used when replacing a light-colored model
material with a darker material (such as Agilus30 Black™ or
VeroBlack™) or if the exact color of the 3D print is unimportant. Use this
cycle when replacing cleaning fluid with any model material.
The wizard flushes the system with the minimum amount of material
needed to ensure that 3D prints have the mechanical properties of the
new material.
❒ Full. Use this cycle when the 3D print must have the exact color of the
new material.
The wizard thoroughly flushes the feed tubes and print heads needed
for printing, based on your selections in the previous screens.
4 Operating and Maintaining the Printer
4-24