Table of Contents
Advertisement
Regulatory firmware
5. Click More in the Devices toolbar and select More > Update > Update Firmware. The Update
Firmware dialog appears.
6. Click Browse to select the file that you unzipped earlier.
7. Click Update Firmware. The updated devices automatically reboot when the updates are
complete.
Note
The update is immediately rejected and an error is returned if the device is going into
sleep mode or is being shut down. See
8. When all changes are complete,
9. Once the regulatory firmware is loaded, configure the XBee for the testing required.
Configure regulatory firmware for testing the Bluetooth
n
Configure regulatory firmware for testing the cellular
n
10. After you have completed your testing using the regulatory firmware, you should
device
firmware.
Configure regulatory firmware for testing the Bluetooth radio
In XCTU or command mode, set the following configurations:
1. Turn on Bluetooth by setting BT=1.
2. Set the API mode to DTM Protocol by setting AP=0.
3. Specify cellular modem as on or off:
If the cellular modem should be off during testing set AM=1.
n
If the cellular modem should be on during testing set AM=0.
n
4. Verify that the serial interface settings are set up as expected for testing.
Configure regulatory firmware for testing the cellular component
You must configure the regulatory firmware in order to use the regulatory test commands for testing
the cellular component.
Prerequisite
A SIM card must be installed in the XBee.
Configure the regulatory firmware
In XCTU or command mode, set the following configurations:
1. If Bluetooth is not required, turn off Bluetooth. Set
2. Disable USB Direct mode, if it is currently enabled. Set
3. Disable airplane mode, if it is currently enabled. Set
4. Configure the XBee in transparent mode. Set
Digi XBee® 3 Cellular LTE-M/NB-IoT Global Smart Modem User Guide
Configure regulatory firmware for testing the Bluetooth radio
Clean
shutdown.
disconnect the device
from Remote Manager.
BT
= 0.
P1
= 0.
AM
= 0.
AP
= 0.
radio.
component.
re-install the
303
Advertisement
Table of Contents
Troubleshooting
