Innovation, Science And Economic Development Canada (Ised); Labeling Requirements; Rf Exposure - Digi XBee 3 Cellular LTE-M User Manual

Regulatory information
2.8 Label and compliance information
Host product manufacturers need to follow the sticker guidelines outlined in
requirements.
2.9 Information on test modes and additional testing requirements
Contact a sales representative for information on how to configure test modes for the XBee Smart
Modem.
2.10 Additional testing, Part 15 Subpart B disclaimer
All final host products must be tested to be compliant to FCC Part 15 Subpart B standards. While the
XBee Smart Modem was tested to be complaint to FCC unintentional radiator standards, FCC Part 15
Subpart B compliance testing is still required for the final host product. This testing is required for all
end products, and XBee Smart Modem Part 15 Subpart B compliance does not affirm the end
product's compliance.
See FCC notices.

Innovation, Science and Economic Development Canada (ISED)

Labeling requirements

Labeling requirements for Industry Canada are similar to those of the FCC. A clearly visible label on
the outside of the final product enclosure must display the following text.
Contains IC: 1846A-XB3M1
Contains IC: 8595A-2AGQN4NNN
The integrator is responsible for its product to comply with IC ICES-003 & FCC Part 15, Sub. B -
Unintentional Radiators. ICES-003 is the same as FCC Part 15 Sub. B and Industry Canada accepts
FCC test report or CISPR 22 test report for compliance with ICES-003.
This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to
the following two conditions: (1) this device may not cause interference, and (2) this device must
accept any interference, including interference that may cause undesired operation of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts
de licence. L'exploitation est autorisée aux deux conditions suivantes: (1) l'appareil ne doit pas
produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique
subi, même si le brouillage est susceptible d'en compromettre le fonctionnement.

RF Exposure

CAUTION! This equipment is approved for mobile and base station transmitting devices only.
Antenna(s) used for this transmitter must be installed to provide a separation distance of at
least 25 cm from all persons and must not be co-located or operating in conjunction with any
other antenna or transmitter.
ATTENTION! Cet équipement est approuvé pour la mobile et la station base dispositifs
d'émission seulement. Antenne(s) utilisé pour cet émetteur doit être installé pour fournir
Digi XBee® 3 Cellular LTE-M/NB-IoT Global Smart Modem User Guide
Innovation, Science and Economic Development Canada (ISED)
OEM labeling
321