Table of Contents
Advertisement
Get started with Digi Remote Manager
Remote Manager Schedules user interface.
n
Remote Manager API Explorer user interface
n
Programming web service calls
n
Note
For any of these methods to work properly, you must have SM/UDP enabled. See
SM/UDP.
Overview: Create a schedule for a set of tasks
When using the
most current firmware
Manager once per day over the SM/UDP protocol to check for any active operations. In order to
perform a set of tasks, the device needs to be told to connect to Remote Manager, perform the
sequence of tasks, and then told to disconnect.
The following provides a template of how to create a schedule for an XBee to connect, perform a set
of tasks and then disconnect:
1. Make sure that SM/UDP is enabled. See
2.
Log into Remote
3. Click Device Management > Schedules.
4. Click New Schedule. The New Schedule page displays.
Note
The Steps to schedule a task wizard may display. Click the x in the upper left corner to
close the wizard. See
more information.
5. In the Description field, enter a name for the schedule, such "Read Settings."
6. Add the following tasks:
a. Click SM/UDP > SM/UDP Request Connect. A task is added to the dialog.
b. Add other tasks as needed. For examples, refer to the
c. Click Device > Disconnect. A task is added to the dialog.
7. Click Schedule in the lower right corner of the dialog to schedule the tasks to run. The
schedule screen displays.
Note
You can also click Save as to save this schedule for future use.
8. Select the device(s) on which you want to run this schedule. You can add more than one device.
9. Click Run Now.
Examples
The examples in the following sections assume you are using the Digi Remote Manager Schedule
wizard. However, you should be aware that operations can be created and performed
programmatically via web service calls or via the API explorer. The XML web service calls provide more
options than are available in the GUI dashboard for some tasks.
Example: Read settings and state using Remote Manager
In order to configure devices you will need to know the structure of the XML for your XBee's settings.
The easiest way to obtain this is to perform a query_setting RCI request against your device.
Digi XBee® 3 Cellular LTE-M/NB-IoT Global Smart Modem User Guide
Configure Remote Manager features by scheduling tasks
version, the XBee Cellular devices are designed to poll Remote
Enable
Manager.
Schedule walk-through feature
SM/UDP.
in the
Digi Remote Manager® User Guide
Examples
section.
Enable
for
52
Advertisement
Table of Contents
Troubleshooting
