Interface With The Xbib-C-Gps Module - Digi XBee 3 Cellular LTE-M User Manual

Hardware
Number Item
1 40-pin
header
2 GPS unit Contains GPS module CAM-M8Q-0-10. Proper orientation is with the board

Interface with the XBIB-C-GPS module

The XBee Smart Modem can interface with the XBIB-C-GPS board through the 40-pin header. This
header is designed to fit into XBIB-C development board. This allows the XBee Smart Modem in the
XBIB-C board to communicate with the XBIB-C-GPS board—provided the XBee device has MicroPython
capabilities (see this link
ways to interface with the XBIB-C-GPS board: through the host board's Secondary UART or through
the I2C compliant lines.
The following picture shows a typical setup:
Digi XBee® 3 Cellular LTE-M/NB-IoT Global Smart Modem User Guide
Description
This header is used to connect the XBIB-C-GPS board to a compatible XBIB
development board. Insert the XBIB-C-GPS module slowly with alternating
pressure on the upper and lower parts of the connector. Do not bend pins
during insertion or removal process.
laying flat, with the GPS module having a clear view of the sky.
to determine which devices have MicroPython capabilities). There are two
Development boards
114