Update The Device And The Cellular Firmware Using Xctu; Update The Device And Cellular Firmware Using Xctu And Usb Direct Access - Digi XBee 3 Cellular LTE-M User Manual

Update the firmware

Update the device and the cellular firmware using XCTU

Use XCTU to update the device firmware, and if needed, XCTU will attempt to update your cellular
firmware.
Update the device and cellular firmware using XCTU and USB Direct access
Note Before you begin, make sure you have XCTU installed and the device is added to the utility. See
Install and upgrade
Update the device and cellular firmware using XCTU and USB Direct
access
You can use XCTU to update the device and cellular firmware. XCTU updates the device firmware to
the version you select, and then, if needed, XCTU will attempt to update your cellular firmware.
Upgrading the cellular component firmware requires USB Direct, which is accessible using an XBIB-
CU-TH development board or from your board design.
WARNING! Version 1140F reorganizes the product's flash memory and upgrades the
product to version 11410. You cannot downgrade to a version earlier than 11410 after
installing 1140F/11410. You also need to use XCTU version 6.4.2 or later.
Prerequisites
Windows PC
n
Digi XCTU version 6.5.0 or newer. You should
n
The device is added to XCTU. See
n
Digi XBIB-CU-TH development board, or your own hardware which enables USB Direct access
n
USB cable for USB Direct access is connected to the PC
n
Cellular component USB drivers are installed
n
To update the device and cellular firmware:
1. Launch XCTU
2. Click the Configuration working modes button
3. From the Radio Modules list, select the device that you want to update.
4. Verify the following configuration. The cellular component firmware update may not work if any
of these settings are enabled. Ensure the following:
Airplane mode is disabled:
n
Bypass mode is disabled:
n
USB Direct Mode is disabled:
n
5. Click Update firmware. The Update the radio module firmware dialog appears and displays
the available and compatible device firmware for the selected XBee module.
6. Select the product family of the XBee module, the function set, and the latest firmware version
for the device.
Digi XBee® 3 Cellular LTE-M/NB-IoT Global Smart Modem User Guide
XCTU.
Add a device to
.
ATAM
ATAP not 5
ATP1
Update the device and the cellular firmware using XCTU
upgrade XCTU to the latest version.
XCTU.
.
set to 0
not 7
82