As (Active Scan For Network Environment Data) - Digi XBee 3 Cellular LTE-M User Manual

AT commands
Parameter
0x00
0x01
0x02
0x03
0x10
0x11
0x12
0xFF
Parameter range
0 - 0xFF (read-only)
Default
-

AS (Active scan for network environment data)

Scans for mobile cells in the vicinity and returns information about the cells in the service area of the
device. When you run the command, the cell module waits until all other communication is idle and
then performs the scan.
The information that can be reported by this command varies based on the network technology of the
module that you are using.
In both AT and API mode the command returns line-based records mapping key-value pairs. The
record for the serving cell begins with the capital letter S, and keys for the fields are MCC, MNC, Area,
CID, and Signal. Each line describes a particular cell and only those values determined during a single
scan are reported.
Example
atas
S MCC:311 MNC:480 Area:48707
Parameter range
0-1
Value
0 or no value
Digi XBee® 3 Cellular LTE-M/NB-IoT Global Smart Modem User Guide
Description
SMS successfully sent.
SMS failed to send.
Invalid SMS parameters - check
SMS not supported.
No network registration.
Cellular component stack error.
A modem update is in-progress. Try again after its completion.
No SMS state to report (no SMS messages have been sent).
Description
Scans for mobile cells in the vicinity and returns information about the cells
in the service area of the module. When you run the command, the cell
module waits until all other communication is idle and then performs the
scan.
Diagnostic interface commands
P# (Destination Phone Number).
229