M0 (Pwm0 Duty Cycle) - Digi XBee 3 Cellular LTE-M User Manual

AT commands
The following table defines the bit-field map for both the PR and PD commands.
Bit I/O line
0 DIO4
1 DIO3/AD3
2 DIO2/AD2
3 DIO1/AD1
4 DIO0/AD0
DIO6/RTS
5
6 DIO8/SLEEP_REQUEST
DIO14/DIN
7
8 DIO5/ASSOCIATE
DIO9/On/SLEEP
9
10 DIO12
11 DIO10
12 DIO11
DIO7/CTS
13
14 DIO13/DOUT
Parameter range
0 - 0x7FFF (bit field)
Default
0x7FFF

M0 (PWM0 Duty Cycle)

Sets the duty cycle of PWM0 (pin 6) for P0 = 2, where a value of 0x200 is a 50% duty cycle.
Before setting the line as an output:
1. Enable PWM0 output
2. Apply the settings (use
The PWM period is 42.62 µs and there are 0x03FF (1023 decimal) steps within this period. When M0 = 0
(0% PWM), 0x01FF (50% PWM), 0x03FF (100% PWM), and so forth.
Parameter range
0 - 0x3FF
Default
0
Digi XBee® 3 Cellular LTE-M/NB-IoT Global Smart Modem User Guide
(P0 (DIO10/PWM0 Configuration)
CN (Exit Command mode)
I/O settings commands
Module pin
pin 11
pin 17
pin 18
pin 19
pin 20
pin 16
pin 9
pin 3
pin 15
pin 13
pin 4
pin 6
pin 7
pin 12
pin 17
= 2).
or AC (Apply Changes)).
213