Use Picocom In Linux - Digi XBee 3 Cellular LTE-M User Manual

Get started with MicroPython
with the device since the baud rate setting is incorrect. You must change this rate as it was
previously set to 115200 b/s.
5. Click Setup and Serial Port. The Tera Term: Serial port setup window appears.
6. In the Tera Term: Serial port setup window, set the parameters to the following values:
Port: Shows the port that the XBee Smart Modem is connected on.
n
Baud rate: 115200
n
Data: 8 bit
n
Parity: none
n
Stop: 1 bit
n
Flow control: hardware
n
Transmit delay: N/A
n
7. Click OK to apply the changes to the serial port settings. The settings should go into effect
right away.
8. To verify that local echo is not enabled and that extra line-feeds are not enabled:
a. In Tera Term, click Setup and select Terminal.
b. In the New-line area of the Tera Term: Serial port setup window, click the Receive drop-
down menu and select CR if it does not already show that value.
c. Make sure the Local echo box is not checked.
9. Click OK.
10. Press Ctrl+B to get the MicroPython version banner and prompt.
Now you can type MicroPython commands at the >>> prompt.

Use picocom in Linux

With the XBee Smart Modem in MicroPython mode (AP = 4), you can access the MicroPython prompt
using a terminal.
Digi XBee® 3 Cellular LTE-M/NB-IoT Global Smart Modem User Guide
Use picocom in Linux
42