I/O Settings Commands; D0 (Dio0/Ad0); D1 (Dio1/Ad1) - Digi XBee 3 Cellular LTE-M User Manual

AT commands

I/O settings commands

The following AT commands are I/O settings commands.

D0 (DIO0/AD0)

Sets or displays the DIO0/AD0 configuration (pin 20).
Parameter range
0, 2 - 6
Parameter Description
0 Disabled
1 N/A
2 Analog input
3 Digital input
4 Digital output, default low
5 Digital output, default high
Cellular component state mirroring (digital output)
6
This option is available in firmware versions ending in *17 and newer. When D0 is set
to 6, the DIO0 pin mirrors the state of the cellular component's power monitoring pin
(V_INT). DIO0 is driven low (0V) when the cellular component is off or in LTE PSM
mode and driven high (3.3V) when the cellular component is powered and active. This
function is primarily for use with USB Direct or Bypass operating modes. Note that
while the XBee is asleep (such as Pin Sleep or Cyclic Sleep), DIO0 will be driven low
and will not update until the XBee leaves sleep.
Default
0

D1 (DIO1/AD1)

Sets or displays the DIO1/AD1 configuration (pin 19).
Parameter range
0 - 6
Parameter
0
1
2
3
Digi XBee® 3 Cellular LTE-M/NB-IoT Global Smart Modem User Guide
Description
Disabled
SPI_ATTN
ADC
Digital input
I/O settings commands
206