Digi XBee 3 Cellular LTE-M User Manual page 26

Get started with the XBee Smart Modem
Make sure you have added the device to XCTU. See
n
Make sure you are in an area with adequate cellular network reception.
n
Verify that the antennas are connected properly to the device.
n
View LED action
The LED on the development board blinks when the XBee is registered to the cellular network; see
Associate LED functionality. If the LED remains solid, registration has not occurred properly.
View commands in SCTU
1. Launch XCTU
2. Click the Configuration working mode
3. Select a device from the Radio Modules list. XCTU displays the current firmware settings for
that device.
4. Verify the status of your network connection using the following commands:
AI (Association Indication)
n
cellular network and the LED is blinking. If it reads 23 it is connecting to the Internet; 22
means it is registering to the cellular network.
MY (Module IP Address)
n
registered yet.
Hints
To search for an AT command in XCTU, use
n
To read a command's value, click the Read button
n
Digi XBee® 3 Cellular LTE-M/NB-IoT Global Smart Modem User Guide
.
reads 0 when the device successfully registers to the
should display a valid IP address. If it reads 0.0.0.0, it has not
Check for cellular registration and connection
Add a device to XCTU.
button.
the search box .
next to the command.
26