Carburetor Idle Speed - Honda V65 MAGNA 1985 Manual

MAINTENANCE
ADAPTERS
CARBURETOR PILOT SCREW
WRENCH 07908-4220201
ADJUSTI -
VACUUM GAUGE 07404-0030000
or M937B-021-XXXXX (USA only)
1
Synchronize to specification by turning the adjust-
ing screws
with
the special tool.
ADJUSTMENT
Start the engine and adjust the idle speed.
IDLE SPEED; 1,000 ± 100
rpm
The No.1 carburetor cannot be adjusted; It is
the base carburetor.
NOTE
Install the vacuum gauge adapter and connect the
vacuum gauge.
Check that all carburetors are within 60 mm (2.4 in)
Hg.
Recheck the idle speed and synchronization.
Remove the gauge adapters and install the plugs.
CARBURETOR IDLE SPEED
NOTE
• Inspect and adjust idle speed after all other
engine adjustments are within specifications .
• The engine must be warm for accurate adjust-
ment. Ten minutes of stop-and-go riding is
sufficient.
Warm up the engine. shift to NEUTRAL, and place
the motorcycle on
its
center stand.
Turn the throttle stop screw as required to obtain
the specified idle speed.
IDLE SPEED: 1,000 ±
lOa rpm
3-15