Carburetor Idle Speed; Carburetor Choke - Honda CM 185T 1981 Manual

INSPECTION/ADJUSTMENT
Minor adjustments are performed w i t h the
upper adjuster.
Adjust w i t h the throttle grip in the closed
position.
Recheck the operation of the t h r o t t l e grip.

CARBURETOR CHOKE

Check the choke knob for smooth operation.
Pull the choke knob out to " f u l l y closed"
and make sure that the choke valve is fully
closed by moving the choke lever on carburetor.
Adjust by loosening the choke cable clamp
on the carburetor. Retighten the clamp, hold-
ing the choke lever " f u l l y closed".
Recheck the choke valve operation.

CARBURETOR IDLE SPEED

NOTE
Check the idle speed after all other
maintenance items have been performed.
Support the vehicle in an upright position.
Warm up the engine.
Turn the throttle stop screw as required to
obtain an idle speed of 1,200 ± 100 rpm.
NOTE
The engine must be warm for accurate
idle speed adjustment. Stop and go
driving for ten minutes should be
sufficient.
Motorcycles manufactured after De-
cember 3 1 , 1977 have the pilot screw
factory pre-set. Do not adjust unless
the carburetor is overhauled.
3-8
Date of Issue: December, 1977
© H O N D A MOTOR CO., LTD.