Dvi Flex Main Yggdrasil Replacement - GE VIVID E9 Service Manual

GE H
EALTHCARE
D GA091568, R
IRECTION
8-11-13

DVI Flex Main Yggdrasil replacement

8-11-13-1 Preparations
When preparing for the replacement, you must perform the following steps:
1.) Power down the VIVID E9.
2.) Disconnect the Mains Power Cable from the wall outlet.
3.) Disconnect all probes.
4.) Remove the Left Side Cover.
5.) Remove the BEP Cover.
a.) Loosen the BEP Cover's fixing screw(s).
b.) Tilt the top of the BEP Cover away from the BEP.
c.) Set the BEP Cover aside.
6.)
Related information:
• 4-2-2 "Power shut down" on page 4-8.
• 8-5-2 "Side Covers replacement" on page 8-38.
8-11-13-2 DVI Flex Main Yggdrasil removal
1.) Disconnect one end of the DVI Flex Main Yggdrasil from the connector on the Graphics Adapter.
2.) Disconnect the other end of the DVI Flex Main Yggdrasil from the DVI-IN connector on the DVR.
8-11-13-3 DVI Flex Main Yggdrasil installation
1.) Install one end of the DVI Flex Main Yggdrasil to the DVI-IN connector on the DVR.
2.) Install the other end of the DVI Flex Main Yggdrasil to the connector on the Graphics Adapter.
3.) Install the BEP Cover.
4.) Install the Left Side Cover.
8 - 288
5
EVISION
- On BEP6 there are two finger screws on the top of the BEP Cover.
- On newer BEP5 there are three Phillips screws, one on the top and one on each side of
the BEP Cover.
- On older BEP5 there is one finger screw at the top of the BEP Cover.
Section 8-11 - Back End Processor (BEP) parts replacement
VIVID E9 S M
ERVICE ANUAL