Connections On The External Io - GE VIVID E9 Service Manual

Hide thumbs Also See for VIVID E9:

Table of Contents

Connections on the External IO

Accessory equipment connected to the analog and digital interfaces must be certified according

to the respective IEC standards (e.g. IEC60950 for data processing equipment and IEC60601-

1 for medical equipment). Furthermore, all complete configurations shall comply with the valid

version of the system standard IEC60601-1-1. Everybody who connects additional equipment

to the signal input part or signal output part of VIVID E9, configures a medical system, and is

therefore responsible that the system complies with the requirements of the valid version of

IEC60601-1-1. If in doubt, consult the technical service department or your local representative

for GE Healthcare.

Connect Ethernet

Connect the Ethernet cable to the Ethernet connector on the External I/O (rear side of VIVID E9).

Figure 3-5 Ethernet connection on rear side of VIVID E9

Connect USB Flash Card

USB Flash Cards approved for VIVID E9 are verified for EMC performance according to

EN55011 class B. The use of any other USB Flash Cards will compromise this verification, and

may cause interference on VIVID E9 itself, or on other electronic devices.

For approved models, see:

Install the USB Flash Card in one of the USB ports on the VIVID E9. Two ports are provided on the

Operator Panel, to the left for the Touch Screen.

Section 9-15 "Peripherals for VIVID E9" on page

Section 3-7 - Completing the setup