Digital Video Recorder (Dvr) Replacement - GE VIVID E9 Service Manual

Hide thumbs Also See for VIVID E9:

Table of Contents

Digital Video Recorder (DVR) replacement

The Digital Video Recorder is a circuit board located in the BEP. The DVR board is connected to a DVD

drive, accessible from the front of the VIVID E9. The DVD drive automatically stores data recorded by

DO NOT TOUCH ANY BOARDS WITH INTEGRATED CIRCUITS PRIOR TO TAKING THE

NECESSARY ESD PRECAUTIONS.

1. ALWAYS CONNECT YOURSELF, VIA AN ARM-WRIST STRAP, TO THE ADVISED

ESD CONNECTION POINT LOCATED ON THE REAR OF THE SCANNER (NEAR THE

POWER CONNECTOR).

2. FOLLOW GENERAL GUIDELINES FOR HANDLING OF ELECTROSTATIC SENSITIVE

RISK OF ELECTRICAL SHOCK, VIVID E9 MUST BE TURNED OFF. AVOID ALL

CONTACT WITH ELECTRICAL CONTACTS, CONDUCTORS AND COMPONENTS.

ALWAYS USE NON-CONDUCTIVE HANDLES DESIGNED FOR THE REMOVAL AND

REPLACEMENT OF ESD SENSITIVE PARTS. ALL PARTS THAT HAVE THE POTENTIAL

FOR STORING ENERGY MUST BE DISCHARGED OR ISOLATED BEFORE MAKING

ENERGY CONTROL AND POWER LOCKOUT FOR VIVID E9.

WHEN SERVICING PARTS OF THE SYSTEM WHERE THERE IS EXPOSURE TO

VOLTAGE GREATER THAN 30 VOLTS:

1. FOLLOW LOCK OUT/TAG OUT PROCEDURES.

2. TURN OFF THE BREAKER.

3. UNPLUG THE VIVID E9.

4. MAINTAIN CONTROL OF THE POWER PLUG.

5. WAIT FOR AT LEAST 20 SECONDS FOR CAPACITORS TO DISCHARGE, AS THERE ARE NO TEST POINTS TO

VERIFY ISOLATION. THE AMBER LIGHT ON THE OP PANEL ON/OFF BUTTON WILL TURN OFF.

BEWARE THAT THE MAIN POWER SUPPLY AND BACK END PROCESSOR MAY BE ENERGIZED EVEN IF THE POWER

IS TURNED OFF WHEN THE CORD IS STILL PLUGGED INTO THE AC OUTLET.

Chapter 8 - Replacement procedures