Bep Power In Cable Replacement - GE VIVID E9 Service Manual

GE H
EALTHCARE
D GA091568, R
IRECTION
8-11-7

BEP Power In Cable replacement

8-11-7-1 Introduction
The J1 chassis connector on the BEP Power In Cable is fixed to the top of the BEP6 frame. The other
end is plugged into PCN 2 on the BEP6 Power Board.
The BEP Power In Cable is included in the BEP6.X Cable Kit - Spare Part, Part Number 5433408-80.
8-11-7-2 Preparations
To get better access, you should remove the BEP from the VIVID E9 before you start to replace the
cable.
1.) Power down the VIVID E9.
2.) Disconnect the Mains Power Cable from the wall outlet.
3.) Disconnect all probes and external cables.
4.) Remove the Left Side Cover.
5.) Remove the Top Cover.
6.) Remove the B/W Printer.
7.) For easier access in the next steps, remove the Front Cover.
8.) Remove the BEP and place it on a table for easy access.
9.) Remove the HDD assembly.
8-11-7-3 BEP Power In Cable removal
Follow these steps to remove the BEP Power In Cable:
1.) Disconnect the cable from PCN 2 on the BEP6 Power Board.
2.) The J1 connector is fixed to the BEP6 frame with two screws (from below) and nuts (above).
Remove the two nuts and screws.
3.) Remove the HDD Bracket. It is fixed to the frame with four Phillips screws from above.
4.) Remove the BEP Power In Cable.
5
EVISION
Chapter 8 - Replacement procedures
VIVID E9 S M
ERVICE ANUAL
8 - 279